Pro-face GP77R Series Connection Manual page 14

SETUP ETHERNET INFORMATION
Enter each item in the SET UP ETHERNET INFORMATION screen.
<GP-477R/GP-577R/GP-2400/GP-2500/GP-2501/GP-2600/GLC2400/GLC2600 Series>
<GP-377R/GP-2300/GLC2300 Series>
• SRC IP ADDRESS (0 to 255)
• SRC PORT NO. (1024 to 65535)
• DEST PORT NO. (1024 to 65535 )
• PROTOCOL TYPE
GP-PRO/PBIII for Windows Device/PLC Connection Manual
Enter the IP address for the GP at your station. To do this, separate the 32 bits
of the IP address into four segments of eight bits each, separate those segments
with a dot and then enter them as decimal numbers.
Enter your GP's Port No. from 1024 to 65535.
Enter the PLC's IP Port No. from 1024 to 65535. Enter the same value as the
PLC's Logic Port No.. When connecting a single GP unit to multiple PLC units,
set all PLC units' Port No. to the same value.
Select UDP/IP or TCP/IP Communication. When the power is turned ON/
OFF asynchronously , Pro-face recommends UDP/IP Communication.
Do not specify duplicate IP addresses. Contact your network manager about
assigning IP addresses.
Hitachi Industrial Equipment System - Ethernet
13