Removal And Replacement Of Front-Accessible Components; Oven Temperature Sensor Removal And Replacement - Thermador Pro Grand PRD304EG Service Manual

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
4.7 Removal and Replacement of Front-Accessible
Components
This section contains removal and replacement procedures for the
components that can be accessed from the front of the range.
4.7.1

Oven Temperature Sensor Removal and Replacement

The oven temperature sensor is located inside each oven cavity
(see Figure 145). Access is needed from both the front and back of
the range in order to replace the sensor bulb.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Remove the backguard (see Backguard and Island Trim Removal
and Replacement, page 68).
3. Remove the back panels (see Back Panel Removal and
Replacement, page 69).
4. Remove oven door (see Oven Door Removal, Installation,
page 77).
NOTE: It is recommended to remove the door, to prevent weight
or force applied from damaging the door and latch components.
5. Remove oven trays.
6. From inside the oven cavity, remove and retain the two screws
(see Figure 145, page 74).
7. At the back of the range, detach the sensor wire connectors.
Fiberglass
Wear gloves when handling fiberglass insulation.
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
8. At the back of the range, while wearing gloves, clear a path in the
fiber glass insulation so the sensor wire connectors can be pulled
through the sensor portal.
9. At the front of the range, gently pull the sensor connector wires
through the portal.
10. Replace the sensor if necessary.
Figure 145: Sensor and Lamp Locations Inside Oven Cavity
1 Lamp
2 Lamp screw
3 Oven temperature sensor screws (2)
4 Oven temperature sensor
Page 74 of 95