Thermador Pro Grand PRD304EG Service Manual page 80

Service Manual for Thermador Pro Grand Dual Fuel Ranges:
10. Remove the reflector cover shield (see Figure 156).
Figure 156: Reflector Cover Shield
Fiberglass
Wear gloves when handling fiberglass insulation.
11. From the back of the range, detach the two convection motor wire
connectors. Be sure to first make a note of how they are
connected (see Figure 157).
NOTE: It is always recommended to label and tag all wires and
harnesses prior to disconnecting them, so as to correctly identify
their connections/locations when re-assembling. Alternatively, you
can photograph the wire connections prior to disconnecting (for
example, with your mobile phone).
58300000157422_ARA_EN_A
PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
Figure 157: Convection Motor Wire Connectors
12. Remove the six screws on the rear cover shield (see Figure 158),
and then pull the rear cover shield (attached to motor assembly)
forward through the oven cavity to remove it.
Figure 158: Screws on Rear Cover Shield
1 Screw locations (6)
13. To detach the motor assembly from the bracket, first remove and
retain the shim ring and washer (see Figure 159, page 82).
14. Remove and retain the four screws from the rear cover shield that
are attached to the bracket (see Figure 160, page 82).
Page 81 of 95