Advanced Settings - Agrowtek GrowControl GC-Pro Operation Manual

Software
The dosing pump outputs and ratios are each displayed separately and indicate which stage of dosing is active.
Advanced Nutrient Dosing Settings
Auto Dose Mode: (ALL or 1 & 2) Select whether all nutrient parts are auto-dosed on demand, or only parts 1 & 2.
Delay After Mode: Select whether the controller will apply the "part delay" time after all parts, or only 1 & 2.
Part Delay Time: (seconds) Time to wait between dosing each part.
Cancel Mode: (Auto Only or Auto & Batch) Disable the "cancel output" when batch dosing only, or when batch dosing and
automatic dosing.
Cancel Output #: Output number to turn off when dosing is active (i.e. feed pump output.)
Cycle Dwell Time: The time to wait before dosing when nutrient level goes low and between each subsequent dosing cycle.
Scheduler: Enable or Disable automatic updates from nutrient scheduler (see scheduler.)
Touch Panel
The advanced nutrient dosing settings are accessed from the 'auto' or 'batch' dosing menu.
Access the "Advanced" settings from the auto or batch dosing menus.
37
www.agrowtek.com
© 2013 Agrowtek Inc.
| 83 Ambrogio Dr Suite H Gurnee, IL 60031 | agrowtek@agrowtek.com
Set auto dose mode, part delay mode,
cancel mode, enable/disable scheduler, set
auto cycle dwell time, part separation
delay time and cancel output#.