Electromagnetic Compatibility - Siemens SINAMICS GL150 Operating And Installation Instructions

NOTICE
Incorrectly opening the doors
If you incorrectly open the doors, then this can damage the locking mechanism.
Open the doors as described in Section "Preparing for use".
See also
Opening doors in preparation for use (Page 65)
Note
Control and signal lines must always be connected according to the circuit diagrams supplied
with the unit. Detailed information about connecting the components is given in the
interconnection diagram.
Note
We recommend using shielded cables. Unshielded cables can transfer disturbances to the
control and signal lines and lead to malfunctions in the drive.
Note
To ensure trouble-free operation without interference or disturbances, route the power cables
and signal lines separately. Interference, for example, will result in the device not behaving as
expected.
When connecting and routing power and signal cables, observe the instructions contained in
the "Electromagnetic compatibility" section.
6.1

Electromagnetic compatibility

The following fundamental information and guidelines facilitate compliance with the EMC
directives.
Note
We recommend that EMC is planned for the entire plant.
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions 04/2017
Electrical connection
6.1 Electromagnetic compatibility
75