Consider Housing Rotation - Emerson Rosemount MultiVariable FOUNDATION 3051SF Series Quick Start Manual

Quick Start Guide
3

Consider housing rotation

To improve field access to wiring or to better view the optional LCD display:
Procedure
1. Loosen the housing rotation set screw.
2. Turn the housing up to 180° left or right of its original (as shipped)
position.
3. Re-tighten the housing rotation set screw.
Figure 3-1: Transmitter Housing Set Screw
Do not rotate the housing more than 180° without first performing a
disassembly procedure (refer to
information). Over-rotation may sever the electrical connection
between the sensor module and the electronics.
3.1 Rotate the LCD display
Transmitters ordered with the LCD display will be shipped with the display
installed.
In addition to housing rotation, the optional LCD display can be rotated in 90°
increments by squeezing the two tabs, pulling out, rotating and snapping
back into place.
If LCD display pins are inadvertently removed from the electronics board,
carefully re-insert the pins before snapping the LCD display back into place.
Use the following procedure and
10
A. LCD display
B. Housing rotation set screw (3/32-in.)
CAUTION
Troubleshooting
Figure 3-2 to install the LCD display:
February 2019
for more
Rosemount 3051SMV