Quick Start Guide
4
Set the switches
Prerequisites
Set Simulate and Security switch position before installation (location of
switches shown in
•
The Simulate switch enables or disables the ability to set simulated alerts
or simulated measured value and status.
•
The Security switch allows (
transmitter.
Figure 4-1: Simulate and Security Switches
A. Security unlocked position
B. Security switch
C. Security locked position
D. Simulate disabled position
E. Simulate switch
F. Simulate enabled position
Further security settings are available in the software, including settings which
use a software lock. Additionally, these settings can be used to disable both
hardware and software locks.
Use the following procedure to change the switch configuration:
Procedure
1. If the transmitter is installed, secure the segment, and remove power.
12
Figure
4-1), as desired.
) or prevents (
A
B
C
February 2019
) any configuration of the
D
E
F
Rosemount 3051SMV