Ah Series - Connect To A Rtu Module; Ahcpu5X1-En Series/Ahcpu560-En2 - Delta AHCPU560-EN2 Series Operation Manual

E t h e r N e t / I P O p e r a t i o n M a n u a l
Click the Network _0 to check the data mapping status and the error codes. For error code
b)
definition, refer to section 6.2.
_4
4.6 AH Series – Connect to a RTU module
This section will provide an overview of how to connect the Delta AH series EtherNet/IP RTU modules such
as AHRTU-ETHN-5A to Delta EIP Scanner and EIP Scanner from other brands. Seet the operation steps
below
.
Delta
EIP
Scanner
N

AHCPU5x1-EN Series/AHCPU560-EN2

4.6.1
AHCPU5x1-EN series with firmware version later than V2.00 and AHCPU560-EN2 supports EtherNet/IP.
Users can connect to Delta AHRTU-ETHN-5A modules via EtherNet/IP. Once the settings are done, users
can use the devices X, Y and D in AHCPU5x1-EN series and AHCPU560-EN2 to control digital and analog
I/O modules connected to AHRTU-ETHN-5A.

Running Process:
Open EIP Builder and add the module AHRTU-ETHN-5A in the Network View. Open HWCONFIG to set up
digital and analog I/O modules of AHRTU-ETHN-5A.
4 - 3 0
Y
Op en
H WC ON FIG
ISPSoft
Se tup s
Op en
R TU
EIP Bu ild er
H WC ON FIG
R TU
EIP Bui ld er
HWC ON FIG
D ow nl oa d
So ftw are
t o AH RTU
Do wn lo ad
Imp ort
EDS fi le
...