4.2.4 IP Modification (BOOTP/DHCP)
To enable the DHCP or BOOTP function again, users will need to use the device software to make that
change. Take the AH10EN-5A series as an example, you will need to go to ISPSoft > HWCONFIG > IP
Manager. Open the IP Manager and set up the IP address receiving mode.
Open
HWCONFIG
Open
EI P Builder
Operation Steps:
1. Refer to section 4.1.1 for how to open the HWCONFIG.
2. Set up the parameters: Enable the IP address receiving mode to BOOTP/DHCP.
2.1 AH10EN-5A
◆
Double-click the device you'd like to change its IP address receiving mode.
◆
You will see the option Network Parameters. Click this option to see the Network Parameters setup
page.
◆
Make changes on the items that you'd like to change their IP address receiving modes and click OK to
confirm the settings.
Set up
parameters
Open
IP Manager
receiving mode
C ha pt er 4 E I P B u il der
Download
HWCONFIG
Set up I P
4_
4 - 1 1