Control Console - Zeiss CenterMax Operating Instructions Manual

Operating modes
Working-hour meter
Quickstop button
When the drives are switched on, the indicator lamp above the switch
lights up.
Key-operated switch (6): The key-operated switch is used to deter-
mine the operating mode in which the measurements are to be car-
ried out.
– MAN: The measurement is carried out manually. The workpiece
is probed by means of the joysticks on the control console. The
maximum speed is limited ➤"Travel speed" on page 3-3.
– OFF: No travel movement possible.
– AUTO: The measurement is carried out automatically, e.g. by
means of a CNC program. Before setting this operating mode, you
should test the CNC program in the MAN operating mode.
The working-hour meter (7) counts the number of hours during
which the drives remain activated.
Push-and-turn switch (8): The quickstop button can be pressed to
stop all travel movements in cases of emergency. It engages when
pressed. All drives are switched off.
The quickstop button must be released before switching on the
drives. Release the button by turning it counterclockwise. Then, the
drives can be switched on again by means of the rotary switch
➤
page 2-8.

Control console

The CenterMax is equipped with the standard control console on
delivery. However, it can also be delivered with the Dynalog control
console on request. Each of these control consoles is described in a
separate manual.
61211-1020202 CenterMax Operating Instructions
Components and their functions
2-9