Burner Control Panel - FULTON RB Series Installation, Operation And Maintenance Manual

Fulton Ltd
3.2.4

BURNER CONTROL PANEL

Note: A gas burner is illustrated, for specific details consult the burner manual supplied with the boiler.
Burner controls and indicators are mounted on the burner. The following controls are typical for
a dual fuel burner, but reference should be made to the burner manufacturer's Operating Manual
for the particular type used.
Burner On/Off/Reset Switch
Three-position switch used to switch on/off and/or reset the burner.
Lockout Indicator
Indicates the burner combustion control relay detects a flame failure condition.
The burner controller can be reset by setting the Burner On/Off/Reset Switch to the RESET
position.
Hand Indicator
This lamp will illuminate when the hand/auto switch mounted inside the burner control panel is in
the hand position, normally used for commissioning only.
Auto Indicator
This lamp will illuminate when the hand/auto switch mounted inside the panel is in the auto
position.
High Pressure Indicator
This lamp is not wired when a high steam pressure alarm/lamp is provided in the boiler control
panel.
Modulating Controller
Controls the firing of the burner within the pressure band selected.
RB-RBC-IOMM-2015-1
Figure. 15 - Burner Control Panel
OPERATION - 3
Page 21