Remote Login; System Requirements; Section 10 Remote Login - Observint N4 User Manual

SECTION 10

Remote Login

Use the Web Client to remotely access your NVR at any time via a PC. Before you access the Web Client, you need to ensure that the
internet settings of the NVR are configured properly.

10.1 System Requirements

The minimum requirements for hardware and OS required to run Web Client are given as below.
Item
CPU
RAM
Hard Drive
Display RAM
Display Resolution
OS
DirectX
Direct3D
Ethernet Adapter
IE
Apple Safari
10.2 Remote login
The instructions and screen shots included herein for an initial login to the NVR use a Microsoft Windows 7 system. If using a
NOTE
Windows 10 or an Apple iOS system, the instructions are similar.
Important notes about remote login:
Remote login to the recorder requires Microsoft
•
You must install SurveillancePlugin.exe to fully use the features of the recorder's Internet interface. Usually this is only installed
•
once, but if a newer version is released, a reinstall may be necessary.
If your computer is on the same network (router) as your recorder, you can usually use the IP address of the recorder for the IE
•
URL.
The recorder features UPnP. If your router also supports this feature, it may be very easy to setup port forwarding in your router
•
for access to the recorder from outside the router's firewall (the Internet).
Minimum
Intel® Core™ i5 CPU
4GB or more
500GB or more
2GB or more
1280 × 1024
Windows 7 or above, Mac OS X® 10.9 or above
DirectX 11
Acceleration Function
10/100/1000M Ethernet Adapter
Microsoft Internet Explorer (Ver. 11, 10, 9, 8). It does not support Microsoft
5.1 or above
©
Recommended
Intel® Core™ i5 CPU or higher
8GB or more
1000GB or more
4GB or more
1920 × 1080
Internet Explorer (IE).
©
N4, N8, N16, N32 NVR V8.1.0 User Manual
SECTION 10: REMOTE LOGIN
Edge.
©
87