Observint N4 User Manual page 40

SECTION 3: CHANNEL - LIVE DISPLAY
b. Select areas for PIR sensing as follows:
To enable PIR sensing in an area of the screen where it is not being sensed, drag a rectangle with the mouse across
*
the area, starting on a segment that is not highlighted, where PIR sensing is disabled.
To disable PIR sensing in an area of the screen where it is being sensed, drag a rectangle with the mouse across the
*
area, starting on a segment highlighted in orange, where PIR sensing is enabled.
c. Right click on the Setup screen to return to the PIR menu, and then click Apply to retain your settings.
4. Click the Alarm button at the bottom of the screen to open the PIR Alarm menu.
PIR ALARM settings
5. Configure the PIR alarms for the camera you are configuring, change the following parameters as needed:
Buzzer: Enable this option to sound an alarm tone when a PIR event is detected. You can set the buzzer duration in
—
seconds when the PIR is detected.
Record: Click the settings icon and choose which channel(s) you want to record when the motion detection is triggered.
—
Post Recording: You can set how long after an event occurs that the NVR will continue to record. The recommended
—
recording length is 30 seconds but it can be set higher up to 5 minutes.
Show Message: Check the select box to display the motion icon on the live view screen when a PIR event is detected.
—
Send Email: You can let the NVR to send you an auto-email when a PIR event is detected. You must configure your email
—
settings to use this feature. See "6.3 Email setup" on page 48.
Full Screen: Check the select box to expand the live view display of the channel to expand to full screen when a PIR
—
event is detected.
Picture, Video to Cloud Uploads: Check the select box(es) to upload images and/or videos to the Cloud service when
—
a PIR event is detected. To enable the cloud service, please see
6. Click Save to retain your settings. You can also click Copy to use your alarm settings with other PIR capable cameras.
7. Right click the mouse to return to the PIR menu.
34 www.Observint.com
"7.2 Cloud settings" on page 53.