Table of Contents
Advertisement
7.5
Adjusting the needle stroke (optional)
Fig. 11: Adjusting the needle stroke
1.
Pull out the needle stroke adjustment screw ( Fig. 11/1) to unfasten it.
2.
Adjust the needle stroke by turning the needle stroke adjustment screw ( Fig. 11/1).
3.
Push in the needle stroke adjustment screw ( Fig. 11/1) to fasten it again.
7.6
Shutting down
7.6.1 Temporary shut-down
1.
End spray process by switching off the control air (connection "St") and in accordance with
the information in the operating instructions of the steam spray system.
2.
Interrupt the spray fluid supply.
7.6.2 Long-term shut-down
1.
End spray process by switching off the control air (connection "St") and in accordance with
the information in the operating instructions of the steam spray system.
2.
Interrupt the spray fluid supply.
3.
Clean steam spray gun (
GB–28
Operating instructions
Ä Chapter 8.3 'Cleaning the steam spray gun' on page 30).
T-Dok-553-GB-Rev.4
mail@krautzberger.com, www.krautzberger.com
Advertisement
Table of Contents
