Setting The Zero Point Of The Needle Stroke Setting; Operation Breaks - Krautzberger A-14 Operating Instructions Manual

Automatic spray gun A-14
6.4

Setting the zero point of the needle stroke setting

Fig. 9
1. Close the air feed.
2. Turn the adjustment nut (Fig. 9/1) by turning clockwise.
3. Open fluid feed.
4. Open the control air feed.
5. Slowly open the adjustment nut (Fig. 9/1) turning counter-clockwise until fluid escapes.
6.5

Operation breaks

1. End the spray procedure by switching on the control air (connection "St").
The atomiser air (connection "Z") is automatically closed in the automatic spray gun.
2. Interrupt the spray fluid supply.
3. If necessary, clean the spray gun (
■ 200-0151
Ä Chapter 7.2 'Cleaning spray guns' on page 25).
ENGLISH
GB–23