Table of Contents
Advertisement
[Auto Power Off]: In order to save power when the camcorder is powered by a battery pack, it will automatically
shut off if left without any operation for 5 minutes.
• Approximately 30 seconds before the camcorder shuts off, [Auto Power Off] will appear. Operating any of the
camcorder's controls while the message is displayed will prevent the camcorder from shutting off.
[Tally Lamp]: When this function is set to [i On], the tally lamp illuminates when the camcorder is recording a
clip; it flashes when the self timer is counting down and flashes at a faster rate when under 2 seconds remain.
[Battery Info]: This option displays a screen where you can verify the battery charge (as a percentage) and the
remaining recording time (
• If the battery pack is exhausted, the battery information may not be displayed.
• The
indicates the battery life of the battery pack. If
If
appears in green, the battery life has partly diminished. If
buy a new battery pack.
[HDMI Time Code]: Allows you to output a time code signal from the HDMI OUT terminal.
[HDMI Rec Command]: When this function is set to [i On] and you use the HDMI OUT terminal to connect the
camcorder to a device compatible with HDMI recording commands, when you start or stop recording with the
camcorder, the other device will also start or stop recording. This function is not available when [HDMI Time
Code] is set to [j Off].
[HDMI Status]: Displays a screen where you can verify the standard of the output signal from the HDMI OUT
terminal.
[Distance Units]: Selects the units to use for the focusing distance display while focusing manually. This setting
also affects units for GPS information when using the optional GP-E2 GPS Receiver.
[Rec Touch Operations]: Select [j Off] and then touch [OK] to lock the touch screen in order to prevent settings
from being changed inadvertently while you record. To cancel, use the joystick to select [i On] and then
select [OK].
[Output Onscreen Displays]: When set to [i On], the camcorder's onscreen displays will appear also on the
screen of a TV or monitor connected to the camcorder. Not available for 4K clips.
[Certification Logo Display]: This displays select certification logos that apply to this camcorder.
• This setting may not be available depending on the country/region of purchase.
[Firmware]: You can verify the current version of the camcorder's firmware. This menu option is usually
unavailable.
[Reset All]: Resets all of the camcorder's settings.
Table of Contents
and
modes) or playback time (
Menus
and
modes).
appears in green, battery life has not diminished.
appears in red, we recommend that you
Menu Options
145
Index
Advertisement
Table of Contents
