Table of Contents
Advertisement
Using the Optional RC-6 Remote Controller
Using the Optional RC-6 Remote Controller
The camcorder can be operated remotely. You can use the optional RC-6 Remote Controller as described in this
section. You can also use the camcorder's network functions and wirelessly connect a compatible device to
40
control the camcorder. For details about wirelessly controlling the camcorder, refer to
Controlling the Camcorder from a Network Device
Operating modes:
Activating the Remote Sensor
1 Press the MENU button.
2 Open the [Wireless Remote Control] submenu.
[ System Setup] > [3] (in
[Wireless Remote Control]
3 Select [i On] and then touch [X].
• To deactivate the remote sensor, select [j Off
Using the Remote Controller to Operate the
Camcorder
When using the remote controller, point it at the camcorder's
remote sensor.
• The position of the delay switch on the remote controller
determines how the remote controller operates. Refer to
the following table.
Delay switch
position
Starts and stops
2
recording a video clip.
Takes a photo, even
‹
while recording a video
clip.
NOTES
• The camcorder may not operate correctly when used under fluorescent or LED lights. Make sure to use the
camcorder away from such light sources as much as possible.
• The camcorder may not operate correctly when a remote controller for another device is pointed at the
camcorder and operated.
• The remote controller may not operate correctly when the remote sensor is located under strong light sources
or direct sunlight.
• The camcorder may not operate correctly when a flash fires. If a flash is being used in the vicinity, deactivate
the remote sensor as described in the previous procedure.
• When the camcorder cannot be operated with the remote controller under normal circumstances, or when it
can only be operated at very close range, replace the battery.
Table of Contents
mode) or [2] (in
mode
mode
Takes a photo after a
2-second delay.
Takes a photo
immediately.
(A 131).
mode) >
] instead.
Remote sensor
Menus
Browser Remote:
[ System Setup]
[3] (in
mode) or
[2] (in
mode)
[Wireless Remote Control]
[j Off
]
Delay switch
(bottom side of
remote controller)
Index
Advertisement
Table of Contents
