Daily Settings; System Start-Up; Lookahead Nozzle Choice - Hardi HC5500 Instruction Book

Daily settings

System start-up

When the HC 5500 is turned on a boot sequence is started while the
controller is initiating it self. If the Controller is put into operation for the
very first time it will prompt for date and time, [Set clock to enable
register]. Please see "Menu 2.4 Set clock" for details on setting of clock.
During start-up it shows information about itself in the following order:
1. A screen showing that the controller is a HC 5500 and a software
version in 3rd line of display. In 4th line of display a serial number
for the specific controller is shown.
2. A screen showing boom length in 3rd line of the display. Number
of sections programmed into the controller are shown in the 4th
line. These datas should reflect the sprayer it is mounted to - if not,
please contact your local HARDI dealer to correct this.
3. If the sprayer is equipped with LookAhead and this is enabled in
the HC 5500 it will promt user for a nozzle choice - see section
"LookAhead nozzle choice". If no LookAhead is available this screen
will not appear and HC 5500 will be ready for use.
4. To prevent unintended Track movements the track selection
switch on the hydraulic control box must be set to "auto", if the HC
5500 is switched on while the boom is unfolded and/or the sprayer
is steered out. The display then tells that "auto" is on. If "auto" has
not been selected, the controller will promt you to select "auto" on.
Press to confirm this and then the controller is ready to use.

LookAhead nozzle choice

If LookAhead or pressure based regulation is enabled the HC 5500 it will
promt user for a nozzle choice at every start-up of the controller. Display
will show last used nozzle by displaying its colour and ISO code in the
display.
If the nozzle used at last spray job is going to be re-used, then press
Selecting another nozzle:
1. Select another nozzle by pressing
2. Confirm the choice by pressing
3. If a selected nozzle holds no LookAhead calibration in the HC 5500
memory then it should be calibrated - see section "Menu 3.7
LookAhead" in the chapter "Menu 3 Calibration".
Custom nozzle flow rate is also defined in "Menu 3.7.X LookAhead
calibration".
or .
.
4 - System setup
HC 5500
S/N XXXXXXXX
BOOM:
SECTIONS:
TRACK: AUTO
Press ENTER
.
SELECT NOZZLE
yyyyyyyyyyyyyyyy
CALIBRATE!
yyyyyyyyyyyyyyyy
SW X.XX
XX.X m
X
ISO XXXX
ISO XXXX
23