Danfoss VLT AQUA Drive FC 202 Design Manual page 163

Electrical Installation Con...
Figure 10.5 Control card wiring path for the E1h. Same routing
path for enclosures E2h and D1h–D8h.
10.4.2 Control Terminals
Figure 10.6 shows the removable drive connectors. Terminal
functions and default settings are summarized in Table 10.5
– Table 10.7.
MG22B222
Design Guide
Figure 10.6 Control Terminal Locations
1
2
1 Serial communication terminals
2 Digital input/output terminals
3 Analog input/output terminals
Figure 10.7 Terminal Numbers Located on the Connectors
Terminal
61
68 (+)
69 (-)
Table 10.5 Serial Communication Terminal Descriptions
Danfoss A/S © 01/2018 All rights reserved.
61 68 69 39 42 50 53 54 55
12 13 18 19 27 29 32 33 20 37
Parameter Default Description
setting
– – Integrated RC-filter to
connect cable shield
if there are EMC
problems.
Parameter – RS485 interface. A
group 8-3* FC switch (BUS TER.) is
Port Settings provided on the
control card for bus
Parameter
–
termination
group 8-3* FC
resistance.
Port Settings
10 10
3
161