Removing The Motherboard - Siemens Simatic IPC547E Operating Instructions Manual

Device maintenance and repair
7.4 Removing and installing hardware
Procedure
Removal
Installation
For installation, follow the steps for removal in reverse order.
7.4.7

Removing the motherboard

Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
device (Page 53)".
● The device is open, see the chapter "Open the device (Page 62)".
● A motherboard
The motherboard as spare part is supplied without processor and memory modules.
● T10 screwdriver
94
1. Remove the cable ties securing the power
cables in the enclosure.
2. Disconnect the cables of the drives and the
motherboard.
3. Remove the highlighted screws.
4. Pull out the enclosure of the power supply
from the IPC housing from the back.
Operating Instructions, 02/2014, A5E32317120-AB
SIMATIC IPC547E