Removing And Installing An Internal Hard Disk - Siemens Simatic IPC547E Operating Instructions Manual

3. Carefully insert the tray back into the removable drive bay on the drive cage.
4. Fold the handle out of the tray as far as it will go and slide the tray fully into the removable
5. Close the handle and lock the tray.
7.4.1.3

Removing and installing an internal hard disk

Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
● The device is open, see the chapter "Open the device (Page 62)".
● T10 screwdriver
Procedure
Removal
SIMATIC IPC547E
1. -
2. -
SIMATIC IPC547E
Operating Instructions, 02/2014, A5E32317120-AB
drive bay with unfolded handle.
Make sure that the tray is completely inserted into the removable drive bay.
Note
The tray must always be locked in the removable drive bay to ensure reliable operation of
the devices with removable drive bays.
device (Page 53)".
Device maintenance and repair
7.4 Removing and installing hardware
SIMATIC IPC547E with short enclosure
Open the front door.
Loosen the two highlighted screws and remove the front
panel.
81