Siemens Simatic IPC547E Operating Instructions Manual page 65

Procedure
SIMATIC IPC547E
Operating Instructions, 02/2014, A5E32317120-AB
Expanding and assigning parameters to the device
6.5 Installing expansion cards
①
1. Hold the bar with the card retainer on both
ends and remove it by pulling it upwards.
The bar is latched on both ends.
2. Remove the slot bracket
card from the required slot.
3. Insert the expansion card into the free slot on
the motherboard.
4. Secure the expansion card with the screw
①
5. Insert the bar with the card retainers.
6. Loosen the card retainer and place it on the
expansion card in the slot
7. Secure the card retainer with the screw
If you are installing a short expansion card,
remove the locking screw from the card retainer
and install it in the opposite hole.
8. Close the device.
②
for the expansion
③
.
④
.
⑤
.
65