Displaying A Defective Hard Disk Of A Raid System In The Raid Software - Siemens Simatic IPC547E Operating Instructions Manual

Device maintenance and repair
7.1 Managing RAID systems
7.1.5

Displaying a defective hard disk of a RAID system in the RAID software

Note
Always replace the defective hard disk with a new hard disk of the same type and capacity.
If an error is detected the defective hard disk must be replaced with a new hard disk to return
to a secure RAID status after an error.
The RAID software indicates the following:
● A defective hard disk
● Details of the functioning hard disk:
The functioning hard disk is indicated by BIOS with its port number or by the RAID
software with its device port number.
The following figure shows the corresponding window in the RAID software with a RAID1
system.
You can find information on how to detect and replace a defective hard disk in the RAID
system in the section "Replacing a defective hard disk drive in the RAID system (Page 83)".
70
Operating Instructions, 02/2014, A5E32317120-AB
SIMATIC IPC547E