Appendix A: Errors And Troubleshooting; Troubleshooting Communication; Troubleshooting Ethernet Communication - SolarEdge SE3000H-US Installation Manual

Appendix A: Errors and Troubleshooting

Appendix A: Errors and Troubleshooting
This appendix describes general system problems, and how to troubleshoot them. For further assistance,
contact SolarEdge Support.

Troubleshooting Communication

Troubleshooting Ethernet Communication

When using Ethernet communication, use the Server Communication Status window to identify the
location of the error:
S e r v e r : L A N
S t a t u s :
x x x x x x x x
< E R R O R
xxxxxxxx is a string of 1s and 0s showing an eight-bit communication connection status. 1 indicates OK
and 0 indicates an error.
Bit
Location
1st LAN Disconnected
2nd DHCP Failed, or Invalid DHCP Config
3rd Gateway Ping Failed
4th G Server Ping Failed
5th
6th Server x Ping Failed
7th
8th Tcp Connect. Failed
62
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
< S _ O K >
< O K >
M E S S A G E >
Error Message Cause and Troubleshooting
Physical connection fault. Check the cable pin-
out assignment and cable connection. Refer to
Creating an Ethernet (LAN) Connection on
page 55
IP settings issue. Check the router and
configuration. Consult your network IT.
Ping to router failed. Check the physical
connection to the switch/router. Check that the
link LED at the router /switch is lit (indicating
phy-link). If OK - contact your network IT,
otherwise replace the cable or change it from
cross to straight connection.
Ping to google.com failed. Connect a laptop
and check for internet connection. If internet
access is unavailable, contact your IT admin or
your internet provider.
Ping or connection to SolarEdge server failed.
Check the SolarEdge server address, under LAN
Conf submenu:
Address: prod.solaredge.com
Port: 22222
Check with your network administrator whether
a firewall or another device is blocking
transmission.