Danfoss VLT AutomationDrive FC 300 Instruction Manual page 75

Specifications
Values are based on a typical motor efficiency (eff2/eff3 border line). Motors with lower efficiency will also add to the power loss in the
adjustable frequency drive and vice-versa.
If the switching frequency is increased compared to the default setting, the power losses may rise significantly.
LCP and typical control card power consumptions are included. Further options and customer load may add up to 0.04 hp [30 W] to the
losses. (Though typically only 0.005 hp [4 W] extra for a fully loaded control card, or options for slot A or slot B, each).
Although measurements are made with state of the art equipment, some measurement inaccuracy must be allowed for (
5) The three values for the max. cable cross-section are for single core, flexible wire and flexible wire with sleeve, respectively.
10 10
10-4
VLT ® AutomationDrive Instruction
Manual
®
MG33AL22 - VLT is a registered Danfoss trademark
▲ ▼
/ 5%).