I Installing The Control Box - Zodiac GenSalt OT Series Instructions For Installation And Use Manual

2.4 I Installing the control box

• The control box must be installed in a dry venti lated equipment room protected against frost, with no pool
maintenance chemicals or similar products stored nearby.
• The control box must be installed at least 3.5 metres from the outer edge of the pool. Always comply with
all applicable installati on codes and/or laws that may apply in the area of installati on.
• It must not be installed more than 1.8 metres from the cell (maximum cable length).
• If the box is fi xed to a post, a waterti ght panel must be fi xed behind the control box (350x400 mm minimum):
Mount the metal hanging bracket shown below to the wall or a waterproof panel, using the screws and
-
wall plugs provided, (illustrati on
Fix the control box to the metal hanging bracket by moving 1 (downwards) and 2 (rightwards) in order to
-
lock the box onto its bracket, (illustrati on
Use of Wi-Fi Direct Mode (depending on model)
sure that the home's Wi-Fi network can be detected in order to select the best locati on for the
control box. A Wi-Fi extender or CPL plugs with Wi-Fi hotspot (not supplied) may be necessary in
certain specifi c cases.
9
31.5 cm
36.4 cm
).
).
9.6 cm
: Take a smartphone (Setti ngs / Wi-Fi menu) and make