I Regular Use - Zodiac GenSalt OT Series Instructions For Installation And Use Manual

5.4 I Regular use

5.4.1 Adjusti ng chlorine producti on
From factory, the chlorinati on is set at 50 %. It can be set between 0 and 100 % in 10 % increments from the "main
screen" by pressing
The term «standard» chlorinati on is used when the chlorine producti on is managed manually (no «Boost»
mode or «Low» mode acti vated and with no ORP regulati on connected)
5.4.2 "Boost" mode
In some cases, the pool may require a higher than normal chlorinati on level such as in cases of high use, poor weather
or at the start of the season. «Boost» mode is used to increase the chlorine level quickly.
«Boost» mode lasts for 24 cumulati ve hours at a producti on rate of 100%. If the program is set to perform chlorinati on
12 hours per day, «Boost» mode will be acti ve for 12 hours on the fi rst day and 12 hours on the second day.
If the fi lter pump is connected to the device, the fi lter pump will operate in «Boost» mode also. The chlorinati on and
fi ltrati on ti mers are temporarily ignored for the durati on of the «Boost» mode.
Once «Boost» mode completes, the device and fi lter pump will resume programmed operati ons.
If the device is equipped with a Dual Link module, the «Boost» mode will not take the ORP value into
account. The «Boost» mode takes priority over the ORP regulati on
• Press .
• If the device is in
or
«Cover» «Low»
5.4.3 "Low" mode
«Low» mode is designed to reduce chlorine producti on in situati ons where the pool is covered or when pool use is
limited. Chlorine producti on needs will be lower when pool use is low and/or when pool water is not exposed to UV rays
etc.
Producti on in «Low» mode may be set in the main menu parameters from «Low/Cover» mode.
«Low/Cover» mode may be set from 0 % to 30 % in 10 % intervals. The programs remain acti ve while the appliance is
in «Low/Cover» mode.
• To manually enter
• To exit mode press
«Low»
37
. The set value is valid unti l the next modifi cati on.
/ mode you will need to confi rm that you want
«Low» «Cover»
mode setti ngs.
mode press
«Low»
again.
.
mode to override
«Boost»