The Remotes Tab - Black Box iPATH ACR1000A-CTL-24 User Manual

4.8 THE REMOTES TAB

The Remotes tab shows a paginated table of all remote devices within the iPATH network.
Click the REMOTES tab to view the initial View Remotes page.
The other Remotes pages (e.g. View Remote Groups, Add Remote Group, etc.) are selectable within the blue section located just
below the tabs.
SEARCH FILTERS
The key fields (Name, Description and Location) all provide a search filter to locate particular items within
long lists. Enter a full or partial search string into the appropriate filter box and then click
search. Optionally use the
The page will reload with the same pagination/sort order, but with the added search filter. It's possible to filter by several columns
at once (e.g. search for all entries with "mac" in the name, and "mixed" in the description). Search terms are case-insensitive. You
can re-sort and paginate on filtered results without losing the filters.
To remove a filter, click the red cross next to the relevant filter, (you can also empty the search box and click
4.8.1 REMOTES > VIEW REMOTES
The table shows the following information for each remote:
• Name
• IP address
• Description & Location
The Manage icons are as follows:
(Note: You can hover your mouse pointer over any icons to reveal additional information):
Configure device: Displays the
Reboot device: Allows you to reboot or reset a unit to its factory settings. A popup will ask which task you wish to carry out.
A reboot is useful if a device enters an unknown state. A reset will return the unit to its factory default state and reset its IP
address (the unit will retain any firmware updates that have been applied).
Identify unit: Causes the LED lights to flash on the front of the selected unit. An alert will be shown if the unit cannot be
contacted (e.g. if it is offline).
Delete device: Confirmation will be requested. You will need to factory-reset any devices that you wish to re-configure to
work with iPATH.
Connect to a channel: A list of available channels is shown, along with connection modes (Video-Only/Shared/Exclusive/
Private). The admin user can thus remotely change channel on any remote.
Disconnect: If a remote is currently connected to a channel, clicking the disconnect icon will end the connection, regardless
of who is connected. Hovering over the icon will show which user is connected, which channel they are connected to, and
when the connection was created.
buttons to invert the order of the listing.
• Online status
• Firmware revision of remote unit
• Manage (admin options - see below)
"Configure Remote" page.
1.877.877.2269
to start the
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
again).
43