Black Box iPATH ACR1000A-CTL-24 User Manual page 29

Route of Last Resort
This option is appropriate when the iPATH server is used in multi-subnet mode. In such cases, it is possible that the iPATH server
is not directly connected to the same sub-network as some or all of the Agility endpoints. Therefore, it will be necessary for the
Agility unit(s) to communicate back to the iPATH server via a gateway device (see Gateway IP Address above). This option is used
to indicate which interface has the gateway configured.
Syslog Enabled
Determines whether Syslog should be used to record log data to an external Syslog server.
Syslog IP Address
The address of the external syslog server.
Note: Ensure that this is not set to the iPATH's IP adress as iPATH cannot log its own syslog messages.
SNMP
This option allows the iPATH to connect to an external SNMP (Simple Network Management Protocol) server. If SNMP is enabled,
there are three connection modes:
• Authentication + privacy
• Authentication only
• No authentication
There are two authentication types SHA or MD5 and two Privacy types AES or DES.
The MIB file can be downloaded from http://<IP>/IPATH-MIB.txt
The response is split into three sections:
The first reports status of each individual endpoint:
deviceIndex,
deviceType,
deviceFirmware,
deviceName,
deviceIdentifier,
deviceIP1,
deviceMAC1,
deviceIP2,
deviceMAC2,
deviceSerialNum,
deviceStatus,
deviceLock,
deviceEth1Status,
deviceEth2Status,
(firmware revision)
1.877.877.2269 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
29