Unitronics UMI-B1 UL Series Operation Manual page 85

UMI-B1 UL Series Inverter
Function
Name
code
P10 Group Simple PLC and multi-step speed control
Simple
P10.00 PLC
means
Simple
PLC
P10.01
memory
selection
Multi-step
P10.02
speed 0
The
running
P10.03
time of
stage 0
Multi-step
P10.04
speed 1
The
running
P10.05
time of
stage 1
Multi-step
P10.06
speed 2
The
running
P10.07
time of
stage 2
Multi-step
P10.08
speed 3
The
P10.09 running
time of
Detailed instruction of parameters
0: Stop after running once. The inverter has
to be commanded again after finishing a
cycle.
1: Run at the final value after running once.
After finish a signal, the inverter will keep the
running frequency and direction of the last
run.
2: Cycle running. The inverter will keep on
running until receiving a stop command and
then, the system will stop.
0: Power loss without memory
1: Power loss memory; PLC record the
running stage and frequency when power
loss.
100.0% of the frequency setting corresponds
to the Max. Frequency P00.03.
When selecting simple PLC running, set
P10.02–P10.33 to define the running
frequency and direction of all stages.
Note: The symbol of multi-step determines
the running direction of simple PLC. The
negative value means reverse rotation.
DEC time
(2 stages)
P10.04
P10.02
ACC time
(2 stags)
P10.03 P10.05 P10.07
multi-step speeds are in the range of
–f
--f and it can be
max max
UMI-B1 UL series inverters can set 16 stages
speed, selected by the combination of
multi-step terminals 1–4, corresponding to
the speed 0 to speed 15.
P10.28
P10.30
P10.06
P10.31
83
Function parameters
Default
value
0
0
0.0%
0.0s
0.0%
0.0s
P10.32
0.0%
P10.33
0.0s
0.0%
0.0s
Modify
○
○
○
○
○
○
○
○
○
○