Unitronics UMI-B1 UL Series Operation Manual page 61

UMI-B1 UL Series Inverter
Function
Name
code
HDI
frequency
P05.54
input filter
time
P06 Group Output terminals
Y1 output
P06.01
selection
Relay RO1
P06.03 output
selection
Relay RO2
P06.04 output
selection
Polarity
selection
P06.05
of output
terminals
Detailed instruction of parameters
0.000s–10.000s
0: Invalid
1: In operation
2: Forward rotation operation
3: Reverse rotation operation
4: Jogging operation
5: The inverter fault
6: Frequency degree test FDT1
7: Frequency degree test FDT2
8: Frequency arrival
9: Zero speed running
10: Upper limit frequency arrival
11: Lower limit frequency arrival
12: Ready for operation
13: Pre-magnetizing
14: Overload pre-alarm
15: Underload pre-alarm
16: Completion of simple PLC stage
17: Completion of simple PLC cycle
18: Setting count value arrival
19: Defined count value arrival
20: External fault valid
21: Reserved
22: Running time arrival
23: MODBUS communication virtual
terminals output
24–25: Reserved
26: Establishment of DC bus voltage
27–30: Reserved
The function code is used to set the pole of
the output terminal.
When the current bit is set to 0, input terminal
is positive.
When the current bit is set to 1, input terminal
is negative.
59
Function parameters
Default
Modify
value
○
0.100s
0
○
1
○
5
○
0