Inverter power filters
General Description
This guide provides basic installation information for the UMI-S0xxx series of input and output power
filters intended for use with Unitronics series of inverters.
The UMI-S0xxx series of power filters offer high insertion loss and low leakage current.
Proper filter selection, along with adequate installation and wiring, can help achieving compliance with
IEC/EN 61800-3 emission levels for C2 or C3 environments for Unitronics inverter installations.
You may find additional documentation in the Technical Library in the Unitronics website:
https://unitronicsplc.com/support-technical-library/
Alert Symbols and General Restrictions
When any of the following symbols appear, read the associated information carefully.
Symbol
Meaning
Danger
Warning
Caution
Caution
Before using this product, the user must read and understand this document.
All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
Please dispose of this product according to local and national standards and regulations.
Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property
damage.
Do not attempt to use this device with parameters that exceed permissible levels.
To avoid damaging the system, do not connect/disconnect the device when power is on.
Environmental Considerations
Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration, in
accordance with the standards given in the product's technical specification sheet.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
Ventilation: 10mm space required between controller's top/bottom edges & enclosure walls.
Electrical Specifications
Filter
UMI-S0020
UMI-S0021
UMI-S0022
UMI-S0023
Unitronics
Description
The identified danger causes physical and property damage.
The identified danger could cause physical and property damage.
Use caution.
Line Voltage
Current [A]
1Ph 220VAC
10
1Ph 220VAC
25
3Ph 380VAC
6
3Ph 380VAC
16
Technical Specifications,
Installation Guide
UMI-S0xxx
For inverter Side
Input
Input
Input
Input
IEC/EN 61800-3
Environment
C2
C2
C2
C2
1