List Of Parts; Replacement Parts - stertil-KONI ST1075-FBF Installation, Operation And Maintanance Instructions

7
2. Set the lever to position 2 and move the drawbar up and down; the cylinder will now
not lift if the setting is correct.
3. If the cylinder lifts, loosen nut 1 and turn the adjusting screw clockwise.
4. If the cylinder sinks down, turn the adjusting screw anti-clockwise until the cylinder
no longer sinks. Raise the cylinder to the top position and set the lever to position 1;
the cylinder should now be lowered.
5. If it does not lower, or only does so slowly, tighten the adjusting screw a little.
6. Repeat these steps until the movements at each lever position are correct.
7. Once the adjustments are correct, re-tighten nut 1.
7.7

List of parts

See appendix
parts - Options" on page
Explanation of the titles of the columns in the parts list:
Fig. & index
No.
Reference
Description
7.8

Replacement parts

You can order replacement parts from Stertil B.V. - see
on page 13
When ordering replacement parts, please supply the following information:
Column lift type:
Serial number:
Reference no.:
Operating instructions (Version 0)
Service and troubleshooting
A "List of parts and appendices" on page 75
93.
Fig. refers to the related group on the
parts drawing.
Index to the section in this group.
Total number of parts in the column lift.
The numbers in this column are Stertil B.V. order numbers.
Please specify these numbers when ordering.
This column contains the name of the parts.
for address details.
ST 1075.
See the type plate on the column lift.
See List of Parts.
69
and appendix B "List of
1.6 "Manufacturer's details"
ST 1075