Preparation; System Functions - stertil-KONI ST1075-FBF Installation, Operation And Maintanance Instructions

5
• the pallet lifting mechanism is set to the bottom position.

5.5.1 Preparation

1. Fit wheel adapters to the forks of the column lifts if necessary.
2. Set up the required number of column lifts.
3. Ensure that the fork of each column lift is extended as far as possible under the
wheel.
4. Lower the pallet lifting mechanism by pulling on the lever that is located on the inside
of the drawbar.
5. Ensure that the mains switch on the control box of the column(s) is set to 0 (OFF).
6. Link the columns - see
7. Check the mechanical safeguard by pressing the UNLOCK button (6) a few times.
You should clearly hear the noise of the pawls.

5.5.2 System functions

All system functions (see
by pressing:
<UP> (button 3)
all columns are raised.
<DOWN> (button 4)
lower into the safety locks.
<UNLOCK> (button 6) and <DOWN> (button 4)
all column lifts are lowered.
<SELECT> (button 5) and <PAIR> (light 11) and <UP> (button 3)
one axle is raised (2 column lifts).
<SELECT> (button 5) and <PAIR> (light 11) and <DOWN> (button 4)
one axle is lowered (2 column lifts).
<SELECT> (button 5) and <SINGLE> (light 10) and <UP> (button 3)
one column lift is raised
<SELECT> (button 5) and <SINGLE> (light 10) and <DOWN> (button 4)
one column lift is lowered.
<TURTLE> (icon) and <DOWN> (button 4)
columns are lowered slowly.
This works for <ALL>, <PAIR> and <SINGLE>.
Note
n
Lower the column lifts into the safety locks and set the mains switch to 0 (OFF) once
the desired height has been reached.
Operating instructions (Version 0)
Operation
5.2.2 "Starting and identification" on page
Figure 5.2 "Control box" on page
41
34.
34) are now available
ST 1075