Information Screen - stertil-KONI ST1075-FBF Installation, Operation And Maintanance Instructions

The buttons for raising, normal lowering and lowering in the safety locks are of the
"dead man" type (hold to run). Operation continues as long as the button remains
pressed, and stops immediately once the button is released.
Note
n
In the event of malfunction, consult the troubleshooting section
(see 7.5 "Troubleshooting" on page

5.2.7 Information screen

The information screen informs the user about various operational statuses.
6
5
Figure 5.7 Information screen
Battery meter:
indicates the charge level of the batteries - see also
on page
Operating symbols:
The screen shows which buttons are pressed.
Lifting Height:
Shows the current height that the column is raised to.
Column number:
Shows the number of the column.
Set size:
Shows the number of columns in this set.
Work timer:
This timer is reset and starts to run as soon as the mobile lift is 2 inches from the
ground. This can be seen by a blinking colon character. The timer stops again as
soon as the mobile lift is lower than 2 inches. This can be seen by the fact that the
colon is shown continuously. This time can be used to determine how long the work
on the vehicle took.
Operating instructions (Version 0)
43.
58).
1
4 3 2
6.2.1 "Daily checks by the user"
38
1. Operating symbols
(e.g. lowering and locking)
2. Work timer
3. Set size
4. Column number
5. Lifting height
6. Battery meter
ST 1075