Service And Troubleshooting; General; Emergency Lowering Procedure - stertil-KONI ST1075-FBF Installation, Operation And Maintanance Instructions

7

Service and troubleshooting

7.1

General

Faults in the column lifts can have simple causes. Check the installation for the
possible causes indicated.
If troubleshooting as described below fails to correct the malfunction, please contact
technical services.
Most errors can be corrected without having to remove the vehicle from the column
lifts. However, it is strongly recommended that you remove the vehicle, if the column
lifts are completely lowered.
When troubleshooting or repairing the column lifts, set them to the lowest position.
If the malfunction makes this impossible, then ensure that all pawls are engaged in
the safety locks (lower without unlocking).
Turn off the mains switch at the control box.
Turn the main switch to the 0 position to do this.
Never loosen or remove any part of the hydraulic system, without first placing the
column lifts in the lowest position or in the safety locks.
Note
n
All repairs carried out on the column lifts by persons other than technical services,
and consequences thereof, are entirely at the user's own risk.
Note
n
Technical service is taken to mean either the Stertil technical service or another
technical service authorized by Stertil.
The following troubleshooting guide can be used to identify possible defects. If in
doubt, contact technical services.
7.2

Emergency lowering procedure

In emergency situations, when it is not possible to lower the column lifts from the
control box, the column lifts can be lowered manually.
Warning
w
The emergency lowering procedure must only be performed by persons who are
trained in this procedure.
Operating instructions (Version 0) 50
7
ST 1075