Error Reports - stertil-KONI ST1075-FBF Installation, Operation And Maintanance Instructions

7.5.2 Error reports

When there is an error, further operations are locked out. This is shown on the
screen as follows:
Other column has an
error/failure
Figure 7.6 Error report
The error has to be cancelled first.
Pressing <SELECT> and <UNLOCK> continuously for 2 seconds resets the system.
Table 7.3 Troubleshooting
Code
04
05
06
07
08
09
10 -
17
Operating instructions (Version 0)
ERROR 5
Screen text Possible cause
Column Another PCB is
software installed.
version too low.
Other column Another column has
has an a problem.
error/fault.
Status error on Only occurs on
another column 1: other
column. column(s) are not
carrying out
instructions.
Output UP too UP button stuck.
long activated.
Output DOWN DOWN button stuck. Check the push button.
too long
activated.
Output UNLOCK button
UNLOCK too stuck.
long activated.
Turn off limit Hydraulic leak in one
columns 1 to 8. of the columns: this
can be recognized by
one of the columns
lagging behind when
raising.
Solution
Fit a PCB with the right
software.
Check the screens on the
other columns.
Restart the system. If the fault
occurs again, contact
technical services.
Check the push button.
Check the push button.
Cancel the fault by pressing
<SELECT> and <UNLOCK>
for 2 seconds.
60 ST 1075