Fitting The Axis Interface And I/O Function Module - Festo SPC200 Manual

2. Fitting

2.4 Fitting the axis interface and I/O function module

This section describes how to fit the I/O function
module SPC-FIO-... and the SPC-AIF-... axis interface.
Axis interface installation
The SPC-AIF-... axis interface, designed as a field unit,
can be attached either vertically or horizontally to a flat
surface using the angle brackets supplied. The follow-
ing areas will be required for installation depending on
the method of fastening:
Method of fastening
Horizontal
Vertical
The dimensions for the four threaded holes for M4 size
bolts and the installation of the angle brackets are
shown in the following figure.
2-14
Area required
approx. 66 mm x 70 mm
approx. 66 mm x 30 mm
SPC200... 9904a