Addressing Dipswitch Configuration For Network Communication; Jumper To Supply Power To The Rj45 Plug - Prolon C1000 Series Hardware Manual

www.proloncontrols.com
Addressing Dipswitch Configuration for Network
4 5 6 7
1 2 3
Figure 1: Addressing Dipswitches
The example in Figure 1 shows the switches 1, 2 and 4 in the ON position.
corresponding values are 1, 2 and 8, giving an address sum of 11.
The ProLon network allows a maximum of 127 addresses, therefore 127 controllers.

Jumper to supply power to the RJ45 plug

The RJ45 jumper lets the user select if voltage that will appear on pin #7 of the RJ45 plug. This can be
used to power a device attached to the RJ45 plug, such as a digital sensor or interface. NOTE: If
multiple C1000 controllers are connected together through the RJ45 plug, only one C1000 should be
supplying power onto the RJ45, otherwise you will be mixing your supply sources and possibly cause
damage. The jumper setups are as follows:
info@proloncontrols.com
www.proloncontrols.com
BASIC ROOFTOP HARDWARE GUIDE
Communication
A unique address must be configured on each controller by setting
the first 7 switches on the addressing dipswitch to the desired value.
These switches are numbered from 1 to 7 and represent a binary
value from 1 to 64 (1, 2, 4, 8, 16, 32, and 64 respectively). The last
switch (#8) is reserved. The value of each switch that is in the ON
position is added together to form the numerical address of the
controller.
No power 24 VAC
1-877-9PROLON
PL-C1000 SERIES
24 VDC
9
Therefore, the
Montréal
1989 rue Michelin Laval,
QC H7L 5B7
TEL:(450) 973-5100
FAX: (450) 973-6186