n Stowing
At the end of each work day (or in prep a ra tion for
trans port ing, push ing, lift ing, or stor age) a qual i fied
op er a tor should put the S3970RT / S3370RT /
S2770RT into its stowed po si tion then lock it.
The cor rect stowed po si tion is shown here.
Figure 10.1 - Correct Stowed Position
To bring the S3970RT / S3370RT / S2770RT into
the Stowed Po si tion use the con trols on ei ther the
ground con trol box or the plat form con trol box to:
1. Fully lower the platform.
2. Use the stabiliser controls to completely
raise all four (4) of the stabilisers.
3. Close the platform entry gate and close all
the doors on the machine.
S3970RT, S3370RT & S2770RT – 13865-1
10. Stowing and Transporting
q
To lock the ma chine:
1. Push the Emergency Stop switch in
(OFF) and set the Main Power switch to
OFF then remove the key (see Figure 10.2).
2. Turn the Battery switch OFF and padlock
it (see Figure 10.3).
n Transporting
q
Trailering
WARNING
Only suit ably trained per sonal are per mit ted
to load theS3970RT / S3370RT / S2770RT
onto trucks.
S3970RT / S3370RT / S2770RTs weigh up to
3620kg (7964lbs) depending on the model.
Loading ramps must be able to support that
weight. Transport trailers must be able to
safely transport that weight.
S3970RT / S3370RT / S2770RT brake and
drive systems are not designed for grades
over 35%. Drive slowly and carefully on all
slopes and loading ramps.
To safely drive the ma chine onto a trans port trailer:
Rev A
Figure 10.2
Figure 10.3
DANGER
page 10 - 1