Installation Procedure, Front Of Printer - Avery Dennison SNAP 500 User Manual

88
5. Instructions for Factory / Field Installation of Top
Sensor Assemblies 580009 & 580011

Installation Procedure, Front of Printer

TO BE NEAR VERTICAL AS POSSIBLE
All manuals and user guides at all-guides.com
The above sensors are alike in mechanical configuration. 580009 is a color contrast
sensor & 580011 is a contrast sensor only.
1. Disconnect Power to Printer.
2. Disconnect Stacker Cable & Remote Control Panel (if so equipped).
3. Remove the Rear Cover (save screws).
4. Remove Web Guide Shaft closest to stock supply unwind and replace
with slotted shaft supplied in kit. The wider slot is to be on top and as
near vertical as possible. Be sure Web Guides move freely on the shaft(s).
SLOTTED SHAFT,
WIDER SLOT TO BE ON TOP &
User's Manual—SNAP™ 500 Printer