User's Manual-Snap™ 500 Printer; Ink; Print; Knife - Avery Dennison SNAP 500 User Manual

76

11.2 Ink

Problem
Ink wrinkles or will not
pull smoothly.
Ink rolls loosely on
Rewind core.

11.3 Print

Problem
Poor print – uneven or
no print.

11.4 Knife

Problem
Knife stops during cut in
stock.
Tape is popping in front
of the knife.
All manuals and user guides at all-guides.com
Probable Cause
1) Ink supply and rewind rolls are
misaligned.
2) Ink buildup on the turn bar(s).
3) Incorrect ink width.
1) Ink rewind roll not turning.
2) Ink rewind roll is too full.
Probable Cause
1) Print head pressure is too
light.
2) Ink rewind roll is too full.
Probable Cause
1) Knife blades are dull.
1) Knife blades are dull.
IF THE RECOMMENDED CORRECTIVE ACTIONS DO NOT
RESOLVE THE PROBLEM (S), CONTACT YOUR LOCAL
AVERY DENNISON REPRESENTATIVE.
User's Manual—SNAP™ 500 Printer
Corrective Action
1) Make sure rewind core is equal to or wider
than the supply roll width.
2) Check that the motor is working and has
back tension on the supply roll.
1) Clean the turn bar(s) with alcohol.
1) Use an ink width ¼" (5 mm) wider than the
tape being printed on.
1) Check that the motor is working.
1) Remove ink rewind roll. Replace ink
rewind roll with an empty core.
Corrective Action
1) Move pressure buttons to opposite position.
2) Ensure that both pressure buttons are set
to the same position.
1) Remove ink rewind rolls and replace with
empty cores.
Corrective Action
1) Refer to section 5.4.1, Removing and
Replacing the Knife Assembly.
1) Refer to section 5.4.1, Removing and
Replacing the Knife Assembly.