Installing The Power Cord; Installing The Pc Interface Cable - Avery Dennison SNAP 500 User Manual

18

2.5.3 Installing the Power Cord

2.5.4 Installing the PC Interface Cable

Serial Port for Communication to Printer
All manuals and user guides at all-guides.com
Figure 5. Right Side of Printer – Rear View
A quick-disconnect power cord is shipped with each 115V printer. The cord for
115V printers will use the standard three-prong plug used in the U.S.A.
If a power cord is not supplied with your printer, and your printer is operating at
a rating other than 115V, you will need to obtain a power cord for your voltage
application. The power cord should have an IEC-320-C13 plug on one end and
the appropriate plug for your power receptacle at the other end.
1. Locate the AC power entry receptacle on the backside of the printer just
below the power switch (see Figure 5).
2. Plug the power cord into the AC power entry receptacle.
If you will be using your AVERY DENNISON SNAP 500 printer with a personal
computer, one of the following computer interface cables is required:
Null-modem serial cable with Part number 581139 connector
•
• USB / Serial adapter – Part number 581140
Ethernet adapter
•
1. Locate the communication cable connectors on the backside of the printer
(see Figure 6).
2. Plug in the serial cable connection to the serial port.
The default serial port configuration is 115,200 baud, no parity, 8 data bits, 1 stop
bit.
User's Manual—SNAP™ 500 Printer
115 V Fuse Line Voltage Setting
AC Connection for Power Cable
Power
Switch