Setting Up The Printer; Attaching The Stacker - Avery Dennison SNAP 500 User Manual

16

2.5 Setting Up the Printer

2.5.1 Attaching the Stacker

Rotary Knife
All manuals and user guides at all-guides.com
Shafts
Figure 4. Rotary Knife and Stacker with Bottom Tipped Out
The stacker and knife are two separate assemblies that can be installed and/or
replaced easily and quickly. For information on removing or adjusting the
stacker, refer to Section 4.2.
1. Locate the two shafts on the printer below the Auxiliary Feed and Knife
assembly (see Figure 4).
2. Slide the stacker onto the two shafts until the backside of the stacker is
beyond the tape size to be run.
NOTE: Be sure to slide the top of the stacker behind the
Nip Roller stripping plate.
3. Connect the stacker interface cable extending from the bottom of the stacker
assembly into the larger connector on the right side of the printer. Rotating
the connector and applying light pressure inward will help engage the
connectors.
NOTE: There is a sleeve on the connector that will snap
when the connector is fully engaged with the mating
connector. The two cables will slide into each other only
when the connectors are properly aligned with each other.
User's Manual—SNAP™ 500 Printer
Label Stop
Stacker Sensor
Switch
Platform