Adjusting Density (Darkness); Adjusting The Stacker - Avery Dennison SNAP 500 User Manual

All manuals and user guides at all-guides.com
39
User's Manual—SNAP™ 500 Printer
Print Head Pressure
Buttons
Contrast Knob
Figure 13. Print Head Components

4.1.2 Adjusting Density (Darkness)

The contrast knob for adjusting print density (darkness) is located between the
two print head pressure buttons (see Figure 13). You may adjust the contrast
knob while printing labels.
The nominal contrast setting is in the center of the rotation.
1. To increase print density, rotate the contrast knob clockwise.
2. To decrease print density, rotate the contrast knob counterclockwise.
You can manually rotate the contrast knob 270 degrees. At maximum value, the
print will not become any darker. In fact, it may actually begin to get lighter.

4.2 Adjusting the Stacker

The stacker on your AVERY DENNISON SNAP 500 printer is adjustable in four
ways: the position of the stacker on the mounting pins, the height of the stack,
the angle at which labels are accumulated in the stack, and the angle of the
platform. Different settings of these adjustments may be needed depending on
the length and width of the labels being printed and the material being used.
There are no incorrect settings, only adjustments that allow the stacker to better
accommodate the size and type of material used for the label being printed and
stacked. You will soon learn the setting that work best for your labels.