Adjusting The Position Of The Print Head - Avery Dennison 64-Series User Manual

03/13 Rev. 5.08-01
Adjusting the position of the
print head

Only for the standard version of 64-05/
06/08!
The print head 0 line can be adjusted va-
riably from 2 mm (from the left edge of the
label) to 13 mm:
1. Loosen both thumb screws (1) and push
the print head to the desired position.

The print head does not have to be
taken off!
2. Tighten the screws again.
3. Loosen the stud screws at the black plastic
disks (2) using a 2 mm allen key (one
screw per disk).
4. Adjust the plastic disks to the same posi-
tion as the inside of the print head.
5. Tighten the stud screws again.
USER MANUAL
64-xx – 64-xx dispenser
1
2
Einrichten


15