Installation; Safety - Olimpia BS-1638 Installation, Programming, Use

4 Installation

This section contains information that regards the design of the installation, the connection of the panel
with its peripherals and all the auxiliary inputs and outputs. The complete knowledge of the panel's
capabilities and its peripheral devices is required for a good installation.
All connection described below must be done with the mains power supply isolated and the
battery cables disconnected.

Safety

4.1
A device cannot be considered that it is used correctly if you do not read the accompanying
documents that are supplied.
This product must be installed, commissioned and serviced only by qualified and trained personnel
according to:

The regulations concerning the installation of electrical devise in a building.

The fire safety regulations.
The instructions of the manufacturer.

- The product operates with a voltage of 220-240V ΑC/50-60Hz and is a class 1 unit. (For safety and
operation reasons it requires that the power earth cable of the building is connected).
- It must be installed to the current electrical installation using a dedicated fuse with a label «Fie
detections system – Do not close the switch».
Installation
4.2
The installation of the panel must be done only by qualified personnel only.
Prior to any maintenance procedures isolate the mains power supply from the panel.
Do not remove or install boards with the mains power active.
During the installation use an anti-static protection wristband to protect the panel from electrostatic
discharge (ESD).
The panel must be permanently mounted.
24 / 47
Date 30/9/2016
File
Document code 921163800_09_007
Page 24 from 47