Fault State - Olimpia BS-1638 Installation, Programming, Use

The first line shows how many alarms exist on the panel. The next line shows the first alarm that
happened and specifically the zone and the name of the zone. The next line shows the last alarm that
was issued with the corresponding information.
When an alarm is issued all the corresponding elements that are connected with the alarm will be
activated. The built-in buzzer will start to sound intermittently. If we want to stop the buzzer we can press
the key "Buzzer Silence" and if we want to stop the sirens we must go to the menu and press «Siren
Silence».
Pressing the key "VIEW ALARMS" will show all existing alarms.

Fault state

2.4
In case of a fault state the yellow LED marked "General Fault" lights. Simultaneously other LEDs can
be lit that describe the origin of the fault. The screen will show addition information regarding the fault.
The third section of the screen shows in sequence the faults of the system. The corresponding LED also
lights to show the fault.
When a fault condition is encountered then the internal buzzer sound continuously and all the elements
connected with the fault are activated. If we require we can stop the buzzer by pressing the key "Buzzer
Silence".
Figure 2-6. Typical indication during an alarm
Figure 2-7. A typical screen during a fault state
10 / 47
Date 30/9/2016
File
Document code 921163800_09_007
Page 10 from 47