Table of Contents
Advertisement
3. Disconnect the negative battery cable and wait for 1 min or more . (See BATTERY
REMOVAL/INSTALLATION [LF] .)
4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
5. Remove the fresh-air duct. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
6. Remove in the order indicated in Fig. 17 .
Fig. 17: Removing/Installing Crash Zone Sensor (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.
7. Install in the reverse order of removal.
8. Turn the ignition switch to the ON position.
9. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
If the air bag system warning light does not operate normally, refer to RESTRAINTS -- ON-
BOARD DIAGNOSTIC system (air bag system) and perform inspection of the system.
SAS CONTROL MODULE REMOVAL/INSTALLATION
2007 Mazda MX-5 Miata Sport
2007 RESTRAINTS Air Bag System - MX-5 Miata
Advertisement
Table of Contents
Troubleshooting
