Table of Contents
Advertisement
02-42
▶Auto Door Lock
1.
The door lock system outputs "LOCK" when the vehicle speed maintains over 30 km/h.
However, it doesn't output "LOCK" when all doors are locked or failed.
2.
If any of doors is unlocked after outputting "LOCK" in step 1, outputs "LOCK" up to 5 times
(except step (1)) at the interval of one second.
3.
If any of
doors
(driver's/passenger's/rear)
4.
If the door that was regarded as fail is changed (UNLOCK to LOCK), it will be recognized
as a normal one.
5.
If any door is regarded as FAIL, the auto door lock function does not work. (if it is
occurred when the vehicle speed is over 30 km/h, the auto door lock output does not
occur even if the vehicle speed falls below 30 km/h and accelerates again to over 30
6.
km/h.) Nonetheless, the central door lock function works properly.
When the system receives "UNLOCK" signal from a door switch, it outputs "LOCK" signals
5 times. If additional "LOCK" signal from another door switch is detected during the
period, the system outputs five "LOCK" signals 5 times for the switch.
7.
The door lock system outputs "UNLOCK" automatically if the "LOCK" output conditions are
established by this function or the key is cycled (IGN=OFF) (even when there is no "LOCK"
output while the vehicle speed maintains over 30 km/h under lock condition).
(If the LOCK condition is established with the ignition switch ON, the system outputs
UNLOCK signal unconditionally when turning the ignition switch to OFF position.)
However, when the ignition key is turned to "OFF" position, the lock output conditions will
be cancelled.
8.
The "FAIL" condition of the door will be erased when the ignition key is turned to "OFF"
position.
T2: 0.5 s
(*1) LOCK: Driver's & Passenger's & Rear door & = Lock
is unlocked
after
5 times
is regarded as "FAIL".
of
"LOCK" outputs,
the
door
Advertisement
Table of Contents
Troubleshooting
